Tach to Hobbs conversion calculator
Rental aircraft are often billed on Hobbs time while maintenance is scheduled on tach time. The two meters rarely agree. This calculator converts between them using a ratio you measure on your own aircraft.
Your inputs
Enter all three values to see a result.
Maintenance and billing follow the meter named in the aircraft records and your rental agreement. This conversion is only as good as the ratio you measured.
What the result means
The converted time is what the other meter would show for the same flying. The ratio is the tach hours that build up for each Hobbs hour over your measured stretch.
The gap is how far the tach reads below the Hobbs. A negative gap means the tach ran ahead.
When this is useful
- Checking a rental bill against the hours in the engine log.
- Turning maintenance hours on the tach into billing time on the Hobbs.
- Working out whether a reserve quoted per tach hour is enough when you track Hobbs time.
How it is calculated
A Hobbs meter runs whenever its trigger is on, commonly oil pressure, so it follows the clock. A tach counts engine revolutions, so it runs at the clock rate only at its calibration RPM and slower below it.
Read both meters before and after a stretch of flying and subtract. Divide the tach time by the Hobbs time to get the ratio. Multiply Hobbs time by the ratio to get tach time, or divide tach time by the ratio to get Hobbs time.
ratio = tach time / Hobbs time over your measured stretch; tach = Hobbs x ratio; Hobbs = tach / ratio- Measured stretch
- 10 Hobbs hours and 8.4 tach hours
- Time to convert
- 1.5 Hobbs hours
1.5 Hobbs hours is 1.26 tach hours, which is 1 hour 16 minutes. The tach read 16 percent below the Hobbs.
Check: Over the measured stretch 8.4 tach hours built up in 10 Hobbs hours, a ratio of 0.84. 1.5 times 0.84 is 1.26. The 0.26 of an hour is about 16 minutes.
Limitations
- The ratio only holds for flying like the stretch you measured. Pattern work and long taxis lower it, and long cruise at the calibration RPM raises it.
- Meters differ between aircraft. Some Hobbs meters run from the master switch or an airspeed switch instead of oil pressure.
- Maintenance rules name the time to use for each interval. The logbook and the maintenance program decide, not this conversion.
- Both meters read in tenths of an hour, so 0.1 on the display means six minutes.
Common mistakes
- Reading the meters as hours and minutes. 1.5 on either meter is one hour 30 minutes.
- Measuring the ratio over a single short flight with a lot of taxi time.
- Using a ratio from a different aircraft.
Sources
Related calculators
Cite this page
Aviation Calculators. "Tach to Hobbs Time Converter." https://aviationcalculators.com/tach-to-hobbs-conversion/
Add the date you read it if your style guide asks for one. If you are quoting a figure in something you publish, please link to this page so readers can check the method and see the assumptions behind it. More on reuse and licensing: press and reuse.