Atmosphere calculators
Air behaves differently depending on its pressure, temperature and density, and those three decide almost everything else an aircraft does. Pressure altitude converts a real altitude into the standard atmosphere so performance charts can be read. Density altitude then folds temperature in, which is what actually decides whether an aircraft will climb on a hot day. Further tools convert altimeter settings between hectopascals and inches of mercury, correct an altitude for cold air, and turn a flight level into an altitude. The rest cover the standard temperature profile and a rough estimate of where cumulus cloud will form.
- Pressure altitudeConvert field elevation and an altimeter setting into pressure altitude.
- Density altitudeField elevation, altimeter setting and temperature into density altitude.
- ISA temperature and deviationStandard temperature at an altitude, and how far today differs from it.
- Convective cloud baseRough estimate of cumulus cloud base from temperature and dew point.
- Altimeter setting converterConvert an altimeter setting between hPa, millibars and inches of mercury.
- True altitudeCorrect an indicated altitude for temperature that is not standard.
- Flight level to altitudeConvert a flight level into an altitude on the local altimeter setting.
Why pilots work these out
Performance charts are written for a standard day that rarely happens. When the air is thinner than standard, because the airfield is high, the day is hot, or both, the engine makes less power, the propeller and wing get less bite, and the take-off roll grows. Density altitude puts all of that into one number a pilot can take to the charts.
Pressure altitude does the same job for the altimeter, which measures pressure and only shows the right height when it is set to the local pressure. Getting either figure wrong is how an aircraft that climbed well on a cool morning struggles on a hot afternoon from the same runway.
Where the standard atmosphere came from
Measuring height by air pressure only works if everyone agrees what the pressure should be at each height. An international standard atmosphere was agreed in Europe through ICAN in 1925, and the United States published its own early in the 1920s. The two were reconciled under the International Civil Aviation Organization, whose Council approved the ICAO Standard Atmosphere on 7 November 1952. NACA adopted it later that month.
That standard is the day performance charts still assume: 15 degrees Celsius and 1013.25 hPa (29.92 inches of mercury) at sea level, cooling by about 2 degrees for every 1,000 feet. On the instrument side, Paul Kollsman designed a sensitive barometric altimeter in 1928. On 24 September 1929 Jimmy Doolittle used one, together with Sperry gyroscopic instruments, to take off, fly a short circuit and land at Mitchel Field, New York, without seeing outside the cockpit.
What these calculators leave out
They are standard-atmosphere calculations. Real air is rarely standard above the surface either, so a density altitude worked out from the airfield temperature describes the runway, not the cruise. Take aircraft performance from the flight manual for your aircraft. The cloud base figure is a rough guide for cumulus in well-mixed air and says nothing about fog, low stratus or frontal cloud.
Sources
Other categories
- Wind and airspeed Crosswind, wind triangles and true airspeed.
- Navigation Distance, heading, timing and decision points.
- Fuel Requirements, endurance, range and weight.
- Flight path and turns Climbs, descents, glides and turn geometry.
- Buying and ownership Loans, running costs, reserves and rent versus buy.
- Flying costs and training Rental, charter, pilot license and type rating costs.