True altitude calculator
An altimeter is calibrated for the standard atmosphere. On a day colder than standard, the aircraft is lower than the altimeter says, and the error grows with height above the station. This calculator estimates the true altitude from the indicated altitude and the temperature.
Your inputs
Enter all three values to see a result.
This is an educational and planning aid. Use current official weather, your aircraft flight manual, and the rules that apply to your flight before you act on any figure here. See the aviation disclaimer.
What the result means
The answer is the height above sea level the aircraft is likely to be at, given that the air between it and the altimeter source is not at standard temperature. Cold air is denser, so pressure falls faster with height, and the altimeter over-reads. Warm air does the opposite.
The correction matters most when terrain or an obstacle sits close to the minimum altitude on a procedure. A cold winter day can take more than a couple of hundred feet off the clearance.
When this is useful
- Checking the real clearance over terrain or an approach minimum on a very cold day.
- Understanding why cold weather altitude corrections are published for instrument approaches.
- Studying the effect of temperature on the altimeter for an exam.
How it is calculated
The temperature deviation is the outside air temperature minus the standard temperature at the indicated altitude. The mean temperature of the standard air column between the station and the aircraft is found from the standard lapse rate.
The height above the station is then scaled by the ratio of the actual mean temperature to the standard mean temperature. True altitude is the station elevation plus that scaled height.
true altitude = elevation + (indicated - elevation) x (mean ISA temperature + deviation) / mean ISA temperature- Indicated altitude
- 3,000 ft
- Elevation of the setting source
- 500 ft
- Outside air temperature
- -10 C
The true altitude is about 2,833 ft, which is 167 ft below the indicated altitude. The air is 19 degrees colder than standard.
Check: A common rule is about 4 percent of the height above the station for each 10 degrees colder than standard. The height above the station is 2,500 ft, and 19 degrees colder is about 7.6 percent, which gives roughly 190 ft. The full calculation gives 167 ft, and the rule over-reads a little.
Limitations
- The deviation measured at the aircraft is assumed to apply all the way down to the station. Real lapse rates vary, so the result is an estimate.
- The model assumes the altimeter is set to a QNH from the station you enter. A setting from a different place changes the result.
- It reports one correction. Published cold temperature corrections on instrument approach charts take precedence.
Common mistakes
- Using the temperature at the surface instead of at the aircraft.
- Entering the aircraft altitude as the station elevation.
- Forgetting that the correction applies to height above the station, not above sea level.
Sources
Related calculators
Cite this page
Aviation Calculators. "True Altitude Calculator: Temperature Correction for Cold Weather." https://aviationcalculators.com/true-altitude/
Add the date you read it if your style guide asks for one. If you are quoting a figure in something you publish, please link to this page so readers can check the method and see the assumptions behind it. More on reuse and licensing: press and reuse.