Altimeter setting converter
Altimeter settings are given in hectopascals in most of the world and in inches of mercury in the United States and Canada. This converter turns one into the other and shows the height error you would carry if you left the altimeter on the standard setting instead.
Your inputs
Enter the value to see a result.
This is an educational and planning aid. Use current official weather, your aircraft flight manual, and the rules that apply to your flight before you act on any figure here. See the aviation disclaimer.
What the result means
The setting is the pressure you dial into the altimeter subscale so that it reads field elevation on the ground. Hectopascals and millibars are the same number. Inches of mercury is a different unit for the same pressure, so 1013 hPa and 29.92 inHg describe the same setting.
The last figure shows why the setting matters. If you fly on the standard setting when the local pressure is different, the altimeter reads the height of the standard pressure surface, not your height above sea level. That is the error shown, in feet.
When this is useful
- Reading a US or Canadian weather report in inches of mercury when your altimeter is marked in hectopascals, or the other way round.
- Setting an altimeter that has only one scale from a clearance given in the other unit.
- Checking how much an altimeter would be out if it was left on the standard setting.
How it is calculated
One inch of mercury equals 33.8638866667 hectopascals. A value in one unit is multiplied or divided by that factor to give the other. Millimetres of mercury use the factor 1.3332236842.
The altimeter error uses the standard atmosphere. The setting is converted to the height of the pressure datum above or below sea level, and that height is the amount an altimeter on the standard setting would be out.
inHg = hPa / 33.8639, and error = 145,442 x (1 - (setting / 1013.25) ^ 0.190263)- Altimeter setting
- 1000 hPa
A setting of 1000 hPa is 29.53 inHg. Left on the standard setting, the altimeter would read about 364 ft higher than the aircraft really is.
Check: The rule of thumb is about 27 ft for each hPa. The setting is 13.25 hPa below standard, and 13.25 times 27 is about 358 ft, which agrees with 364 ft.
Limitations
- The conversion between units is exact. The altimeter error is for the standard atmosphere, so real temperatures change it slightly.
- The range accepted is 850 to 1100 hPa. Settings outside it are not real reports.
- Some countries quote a QFE setting, which reads zero on the ground. This converter is for QNH.
Common mistakes
- Entering 29.92 with the unit left on hPa. Choose the unit that matches the number.
- Reading a setting from one weather report and applying it a long way from the station that reported it.
- Treating the standard setting as a safe default. Below standard pressure, the altimeter reads high and the aircraft is lower than it shows.
Sources
Related calculators
Cite this page
Aviation Calculators. "Altimeter Setting Converter: hPa, Millibars and inHg." https://aviationcalculators.com/altimeter-setting-converter/
Add the date you read it if your style guide asks for one. If you are quoting a figure in something you publish, please link to this page so readers can check the method and see the assumptions behind it. More on reuse and licensing: press and reuse.